Dust and debris buildup in the ductwork
We run a rotary brush system and air whip through every branch line under negative pressure, then HEPA vacuum the whole system. The source of the dust is removed, not just moved around.
If your vents are blowing dust and your allergies never quit, an AC cleaning service Lewisville TX homeowners call first can fix it. We pull the blower, scrub the evaporator coil, and run a negative air machine through every branch line. Our team serves Denton County with air conditioner cleaning Lewisville Texas residents trust for real results. Same-day slots are open this week.

An AC cleaning service Lewisville TX is a full mechanical cleaning of the air-handler, evaporator coil, drain pan, and connected ductwork that moves conditioned air through your home. We pull the blower assembly, wash the coil with coil cleaner, vacuum the cabinet with a HEPA vacuum, and run a rotary brush system through each supply and return branch. Every register gets pulled and washed. Every trunk line gets inspected with a duct inspection camera before we call the job done.
Lewisville sits in Denton County where summer heat pushes systems to run 10 to 14 hours a day from May through September. That run time pulls in North Texas dust, cedar pollen, and pet dander, and it all sticks to the wet side of the evaporator coil. Add the older flexible duct in Meadow Glen and Fox Hollow homes, and you get restricted airflow, musty smells, and a system that runs longer than it should. That is why an air conditioner cleaning in Lewisville Texas is not a luxury here.
Every job is a full-system clean, not a vent wipe-down. Here is what is covered on a standard residential visit, and what we can add on the same trip.
We pull the coil access panel, spray it with coil cleaner, and rinse until the fins are clear. This is the single biggest airflow improvement on most jobs. A dirty coil can cut airflow by 30 percent or more.
The blower assembly comes out and gets washed by hand. Caked-on dust on the wheel throws it out of balance and shortens motor life. We clean it, check the capacitor, and reinstall it.
Every supply and return branch gets brushed with a rotary brush system and air whip, then HEPA vacuumed under negative pressure. Flexible duct gets a gentler pass so we do not tear the liner.
We scrub the drain pan, flush the condensate line, and verify it drains freely. A clogged line is the number one cause of water damage around an air handler in Lewisville attics.
Every supply and return cover gets pulled, washed, and reinstalled. We vacuum the boot behind each one. Small detail, but it is where a lot of the visible dust in your home comes from.
We reseal every joint we opened with mastic and foil tape, then run a blower door test to confirm the system is pulling the airflow it should. You get before-and-after photos of the coil and plenum.
We start by walking the house with you, counting registers, and running a duct inspection camera down the main trunk. That tells us whether you have flexible duct, sheet metal duct, or a mix, and where the worst buildup sits. Takes about 15 minutes.
We seal every supply and return register with vent covers, hook a negative air machine to the plenum, and pull the whole system under negative pressure. That keeps dust from blowing back into your living space while we work. Setup runs 20 to 30 minutes.
The blower assembly comes out and gets washed by hand. The evaporator coil gets sprayed with coil cleaner, rinsed, and blown dry with a compressed air nozzle. We scrub the drain pan and flush the condensate line so nothing drips into the cabinet.
We feed a rotary brush system and air whip through each branch line, then chase it with the HEPA vacuum. Flexible duct gets a gentler pass so we do not tear the liner. Sheet metal duct gets the full brush and whip treatment. This is the step that takes the longest, usually 90 minutes to two hours.
We reseal every joint we opened with mastic and foil tape, reinstall registers, and run a blower door test to confirm airflow. You get before-and-after photos of the coil, the plenum, and one representative branch line. Total job time runs three to five hours.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Pulls the entire duct system under negative pressure during cleaning so dust cannot escape into your living space.
Captures fine particles down to 0.3 microns. We use Abatement Technologies units on every residential and commercial job.
Rotobrush equipment that scrubs the walls of sheet metal and flexible duct without tearing the liner.
High-pressure air lines that knock loose debris from duct walls and push it toward the vacuum.
Lets us see inside every run before and after cleaning, and gives you photo proof of the work.
Used to blow out the evaporator coil fins and the blower wheel after washing.
Applies an EPA-registered product inside the cabinet and ductwork to knock down mold spores and odors after cleaning.
The homeowner had two golden retrievers and a system that had never been cleaned in eight years. The blower wheel was caked with hair, the coil was matted, and airflow at the farthest register was barely a trickle. Dust settled on furniture within a day of cleaning.
We pulled the blower and washed it, cleaned the coil, and ran the rotary brush through every branch line. Airflow at the far register improved by roughly 35 percent. The homeowner measured it with an anemometer we left behind for the day.
Original sheet metal duct in the slab, never cleaned. The camera showed 40 years of debris in the low spots and two disconnected joints in the trunk. The hallway smelled musty every time the AC ran, and the family had been dealing with it for years.
We cleaned the full trunk and every branch, resealed the disconnected joints with mastic and foil tape, and fogged the cabinet. The musty smell was gone the same day. Airflow improved enough that the system stopped short-cycling.
The homeowner heard scratching in the attic in January. By March, the system was pulling attic air and insulation fibers into the house, and the return duct had a six-inch tear. Dust was visible on every surface and the family was coughing at night.
We replaced the torn flex duct section, cleaned the full system under negative pressure, and sealed every joint we opened. The camera confirmed no remaining contamination. The homeowner noticed the air smelled clean within a day.
Most Lewisville homeowners call us because something is already wrong. Here are the four issues we see most, and what happens if you let them go.
Ask a pro →We run a rotary brush system and air whip through every branch line under negative pressure, then HEPA vacuum the whole system. The source of the dust is removed, not just moved around.
We scrub the drain pan, flush the condensate line, and fog the cabinet with an EPA-registered product. We also check the coil for standing water and fix the drainage issue that caused it.
We pull the coil, wash it with coil cleaner, and rinse until the fins are clear. Airflow typically improves 20 to 40 percent, and the system stops short-cycling.
We inspect every run with a duct inspection camera, remove contaminated sections, and replace torn flex duct. We reseal the joints with mastic and foil tape so nothing gets back in.
Most residential jobs run $350 to $750 in 2026, depending on the number of vents, system size, and how much buildup we find. A single-system 1,800-square-foot home with 12 vents usually lands around $450. Commercial and industrial jobs are quoted after a walkthrough. We give you the number before we start, and it does not change.
Every two to three years for a typical Lewisville home, and every year if you have pets, allergies, or a family member with asthma. Homes near the Corporate Drive Corridor or any active construction should be on the annual schedule because of the extra dust load. If you have never had it done and the house is over five years old, book it now.
Yes. Our AC cleaning service includes full duct cleaning on every connected branch line, plus the evaporator coil, blower wheel, drain pan, and cabinet. We do not split those into separate line items. Dryer vent cleaning is a separate service because it is a different system, but we can bundle it on the same visit.
BreezeVent Renew offers AC cleaning service in Lewisville and across Denton County, with same-day and 24/7 dispatch available. We are licensed and insured in Texas, our techs carry NADCA ASCS credentials, and we use Rotobrush and Nikro equipment on every job. Call (214) 644-8299 to book.
Same-day and 24/7 dispatch across Denton County. Flat-rate pricing, licensed and insured techs, and before-and-after photos on every job. Call (214) 644-8299 and we will get a truck headed your way.
Book Now (214) 644-8299 →Call us at (214) 644-8299 and you will talk to a real person, not a call center. We answer weekdays from 8 a.m. to 6 p.m., and our on-call tech takes emergency calls around the clock. Most quotes take five minutes on the phone, and same-day appointments are usually available if you call before noon.